Space-Division Multiplexing in Optical Communication Systems
Extremely Advanced Optical Transmission with 3M Technologies
https://doi.org/10.1007/978-3-030-87619-7
Springer Series in Optical Sciences book series (SSOS,volume 236)

Chapter 7 High power issues
Toshio Morioka, Kazi S. Abedin, Nobutomo Hanzawa, Kenji Kurokawa, Kazunori Mukasa, Ryo Nagase, Hidehiko Takara, Shin-ichi Todoroki, Makoto Yamada & Shuichi Yanagi
Pages 409-451 https://doi.org/10.1007/978-3-030-87619-7_7

I wrote “7.1.1 Basic Properties.”

D. Tokunaga, S. Sato, H. Hidai, S. Matsusaka, A. Chiba and N. Morita: “A
novel method of triggering fiber fuse inside glass by optical breakdown and
glass drilling as its application”, Applied Physics A, 400 (2019).
doi: 10.1007/s00339-019-2691-9

CW and pulse laser light beams are focused at a point in the glass. The pluses induce plasma which grows with the CW light. Video clips available.

S. Todoroki: “Quantitative evaluation of fiber fuse initiation with exposure to arc discharge provided by a fusion splicer”,
Scientific Reports, 6, 25366 (2016). doi: 10.1038/srep25366

The conditions required for a fiber fuse initiation in standard single-mode fibers were determined quantitatively. Systematic investigation on the energy flow balance between these energy sources revealed that the initiation process consists of two steps; the generation of a precursor at the heated spot and the transition to a stable fiber fuse. The latter step needs a certain degree of heat accumulation at the core where waveguide deformation is ongoing competitively. This method is useful for comparing the tolerance to fiber fuse initiation among various fibers with a fixed energy amount that was not noticed before.

H. Hidai, N. Saito, S. Matsusaka, A. Chiba and N. Morita:
“Deep drilling of silica glass by continuous-wave laser backside irradiation”,
Applied Physics A, 122, p.277 (2016).

~200W@1095 nm, Aspect ratio: 30 in a thickness of 3mm

H. Pourbeyram, E. Nazemosadat, and A. Mafi:
“Detailed investigation of intermodal four-wave mixing in SMF-28: blue-red generation from green”
Optics Express Vol. 23, Issue 11, pp. 14487-14500 (2015)
doi: 10.1364/OE.23.014487

Y. Mizuno, N. Hayashi, H. Tanaka, K. Nakamura and S. Todoroki:
“Polymer fiber fuse characterization improves propagation possibilities”,
Laser Focus World, 51, 3, pp. 49-52 (2015).

2 presentations will be given at OFC 2015.

W2A.33 (Poster)

S. Todoroki: “Quantitative evaluation of fiber fuse initiation probability
in typical single-mode fibers”
An introductory video is published at YouTube.

W4I.5 (Oral)

N. Hanzawa, K. Kurokawa, K. Tsujikawa, T. Mori, M. Wada and F. Yamamoto:
“Fiber fuse propagation in LP11 mode in few-mode fiber”

S. Todoroki: “Fiber fuse — light-induced continuous breakdown of silica glass optical fiber”, NIMS Monographs, Springer Japan, Tokyo (2014). doi: 10.1007/978-4-431-54577-4

see Fig. 14 in

R. Mary, D. Choudhury and A. K. Kar:
“Applications of fiber lasers for the development of compact photonic devices”,
Selected Topics in Quantum Electronics, IEEE Journal of,
(Volume:PP, Issue: 99, 2014).
10.1109/JSTQE.2014.2301136

Y. Mizuno, N. Hayashi, H. Tanaka, K. Nakamura and S. Todoroki:
“Observation of polymer optical fiber fuse”,
Appl. Phys. Lett., 104, 043302 (2014).

Unofficial video abstract: